Samsung Galaxy J2 (2016) (SM-J210F)
J210FXXU0ARL1 Firmware for Samsung Galaxy J2 (2016) (SM-J210F) — BNG
Firmware Information
- PDA Version
- J210FXXU0ARL1
- CSC Version
- J210FODD0ARL1
- CSC Code
BNG - Bangladesh- Size
- 1.2 GB
- Build Date
- 2019-01-03
- Downloads
- 0
- Device Name
- Samsung Galaxy J2 (2016)
- Model Code
- SM-J210F
- Brand
- Samsung
- CSC Region
- BNG - Bangladesh
- Firmware Package
- Full files
- Status
- Active
- Added On
- 2026-07-22
- Updated On
- 2026-07-28
- Total Downloads
- 0
Compatibility
This firmware is compatible with Samsung SM-J210F. Check your model code, CSC, and device region before flashing.
Inside the ZIP File Breakdown
| File Type | File Size | Description | Extension | Download |
|---|---|---|---|---|
| AP | 2.05 GB | System, recovery, vendor, and main Android partitions. | .zip | Download |
| BL | 3.69 MB | Bootloader package required for device startup. | .zip | Download |
| CP | 18.35 MB | Modem and cellular radio firmware package. | .zip | Download |
| CSC | 80.31 MB | Regional carrier settings and customization data. | .zip | Download |
Verify your download
Compare this MD5 checksum against the file you downloaded to confirm it wasn't corrupted or tampered with in transit.
77e6e12da9fd91f6efec5e1be56e810aThis is the free official stock ROM for the Samsung Galaxy J2 (2016) (SM-J210F), specific to the BNG region. This firmware has the PDA version J210FXXU0ARL1 and runs on Android 6.0.1 with a bootloader binary revision of Bit 0. Download this flash file to safely update or repair your device.
Samsung Galaxy J2 (2016) Firmware ArchiveHow to Flash Samsung Galaxy J2 (2016) Firmware with Odin
- 1
Download & Extract Files
Download the firmware ZIP and Odin tool from ZipFirmware. Extract both archives to a local folder — avoid paths with spaces or special characters.
- 2
Boot into Download Mode
Power off your Samsung device. Hold Vol Down + Power (or Vol Down + Bixby + Power on older models) until the warning screen appears, then press Vol Up to confirm.
- 3
Connect via USB & Confirm COM Port
Open Odin as Administrator on your PC and connect your device via USB. When the ID:COM box turns blue and shows "Added!", your device is recognized and ready to flash.
- 4
Load Firmware Files into Odin Slots
Click the BL, AP, CP, and CSC buttons in Odin and select the matching .tar.md5 files from your extracted firmware folder. Never mix files from different firmware versions.
- 5
Flash & Verify Success
Click Start. Odin flashes each partition in sequence. When the bar turns green and shows "PASS!", the flash is complete. Your device reboots automatically — do not disconnect USB until finished.