ZipFirmwareZipFirmware
loginregister
ZipFirmware

Service & Combination Files (Factory Binaries)

Explore, Download, and Update with Ease

Expert-grade combination files and factory binaries for Samsung mobile repair. Essential tools for FRP bypass, IMEI repair, and deep diagnostics.

Samsung Galaxy On7 (2016) (SM-G610K) combination iconSamsung Galaxy On7 (2016) (SM-G610K)
Samsung Galaxy On7 (2016) product image

G610KKKU2CTI1 Combination File for Samsung Galaxy On7 (2016) (SM-G610K)

Combination Information

Combination Version
G610KKKU2CTI1
FA Version
FA810
Bit / SW REV
2
File Size
2.4 GB
Change List
2020-09-25
Downloads
0
Device Name
Samsung Galaxy On7 (2016)
Model Code
SM-G610K
Brand
Samsung
Package Type
Combination service firmware
Status
Uploading
Added On
2026-07-30
Updated On
2026-08-07
Total Downloads
0

Service-file compatibility

This Combination package is intended for service and diagnostic work on SM-G610K with Bit / SW REV 2. It is not a daily-use firmware. Verify the exact model and bootloader revision before flashing.

Download the free combination file (Factory Binary) for the Samsung SM-G610K. This service firmware (G610KKKU2CTI1) is essential for technicians to bypass FRP (Factory Reset Protection), perform deep software diagnostics, and repair baseband or IMEI issues. Use with caution.

More Samsung Galaxy On7 (2016) Combination Files
Device MobileVersionBit - SW
REV		FAChange listUpdatedStatus

Showing 0 to 0 of 0 entries

How to Flash Samsung Galaxy On7 (2016) Firmware with Odin

  1. 1

    Download & Extract Files

    Download the firmware ZIP and Odin tool from ZipFirmware. Extract both archives to a local folder — avoid paths with spaces or special characters.

  2. 2

    Boot into Download Mode

    Power off your Samsung device. Hold Vol Down + Power (or Vol Down + Bixby + Power on older models) until the warning screen appears, then press Vol Up to confirm.

  3. 3

    Connect via USB & Confirm COM Port

    Open Odin as Administrator on your PC and connect your device via USB. When the ID:COM box turns blue and shows "Added!", your device is recognized and ready to flash.

  4. 4

    Load Firmware Files into Odin Slots

    Click the BL, AP, CP, and CSC buttons in Odin and select the matching .tar.md5 files from your extracted firmware folder. Never mix files from different firmware versions.

  5. 5

    Flash & Verify Success

    Click Start. Odin flashes each partition in sequence. When the bar turns green and shows "PASS!", the flash is complete. Your device reboots automatically — do not disconnect USB until finished.