Samsung Galaxy S20 FE 5G (SM-G7810)
G7810ZHUHHZE1 Combination File for Samsung Galaxy S20 FE 5G (SM-G7810)
Combination Information
- Combination Version
- G7810ZHUHHZE1
- FA Version
- FA13
- Bit / SW REV
- H
- File Size
- 6.2 GB
- Change List
- 2026-05-14
- Downloads
- 0
- Device Name
- Samsung Galaxy S20 FE 5G
- Model Code
- SM-G7810
- Brand
- Samsung
- Package Type
- Combination service firmware
- Status
- Uploading
- Added On
- 2026-07-31
- Updated On
- 2026-09-06
- Total Downloads
- 0
Service-file compatibility
This Combination package is intended for service and diagnostic work on SM-G7810 with Bit / SW REV H. It is not a daily-use firmware. Verify the exact model and bootloader revision before flashing.
Download the free combination file (Factory Binary) for the Samsung SM-G7810. This service firmware (G7810ZHUHHZE1) is used by authorized repair technicians to reset Factory Reset Protection (FRP) after service, run software diagnostics, and restore baseband or IMEI on a device they own or are authorized to service. Use only on your own device, or with the owner's permission.
More Samsung Galaxy S20 FE 5G Combination Files| Device Mobile | Version | Bit - SW REV | FA | Change list | Updated | Status |
|---|---|---|---|---|---|---|
How to Flash Samsung Galaxy S20 FE 5G Firmware with Odin
- 1
Download & Extract Files
Download the firmware ZIP and Odin tool from ZipFirmware. Extract both archives to a local folder — avoid paths with spaces or special characters.
- 2
Boot into Download Mode
Power off your Samsung device. Hold Vol Down + Power (or Vol Down + Bixby + Power on older models) until the warning screen appears, then press Vol Up to confirm.
- 3
Connect via USB & Confirm COM Port
Open Odin as Administrator on your PC and connect your device via USB. When the ID:COM box turns blue and shows "Added!", your device is recognized and ready to flash.
- 4
Load Firmware Files into Odin Slots
Click the BL, AP, CP, and CSC buttons in Odin and select the matching .tar.md5 files from your extracted firmware folder. Never mix files from different firmware versions.
- 5
Flash & Verify Success
Click Start. Odin flashes each partition in sequence. When the bar turns green and shows "PASS!", the flash is complete. Your device reboots automatically — do not disconnect USB until finished.